 |
| Main Drain Cover 12 inch Square - Hayward |
Certified to Comply with Section 1404 of the Virginia Graeme Baker Act (VGB) Pool & Spa Safety Act
Test Results can be obtained from: www.Haywardnet.com and/or http://www.nsf.org/Certified/Pools/
Manufactured: Between October 2008 and December 2008, by Hayward Pool Products in Pomona, CA, a Division of Hayward Industries, Inc. 620 Division Street, Elizabeth, NJ 07207, Phone 9083515400
Tested to ANSI/ASME 112.19.82007 (addendum 8a2008) per Section 1404 of the Virginia Graeme Baker Act (VGB) Pool & Spa Safety Act. Certified by NSF International, 789 N. Dixboro, Road, Ann Arbor, MI. 48105 1(800)NSFMARK.
Certificates of Compliance:
9" x 9" Square Grate
12" x 12" Square Grate
18" x 18" Square Grate
Installation Manual for Hayward SUCTION OUTLET FRAMES & COVERS |
|
|
|
|
 |
| Main Drain Cover Round - Hayward |
THIS IS A PLASTIC DOMED MAIN DRAIN SUCTION COVER
THIS GRATE IS USED ON A NUMBER OF HAYWARD MAIN DRAINS
THIS WOULD ALSO REPLACE THE NO LONGER AVAILABLE SPX1048C WHICH
WAS THE OLDER STANDARD GRATE.
OUTSIDE DIAMETER: 7-3/4"
HEIGHT: 1 1/2"
GRATE SCREW HOLES
HOLE TO HOLE: 6"
(CENTERLINE MEASUREMENT - CENTER OF HOLE TO CENTER OF HOLE)
THERE ARE 4 REINFORCING TABS ON THE BOTTOM OF THE GRATE.
THE SCREW HOLES ARE BETWEEN 2 OF THE TABS.
THERE ARE NUMEROUS HOLES IN CENTER PORTION OF THE COVER
AND NUMERIOUS SLOTS AROUND THE OUTER EDGE
MARKINGS:
"HAYWARD WG1048 E"; WARNING: SUCTION CAN CAUSE RISK OF DROWNING,
DISEMBOWELMENT, HAIR, LIMB OR BODY ENTRAPMENT, DO NOT USE POOL IF COVER
IS LOOSE, DAMAGED, CRACKED OR MISSING.; AND USE ONLY SUPPLIED SCREWS TO
SECURE COVER IS MOLDED ON TO THE TOP OUTER EDGE OF THE COVER.
WARNING! WITH LOGO (TO DRAW ATTENTION TO READ THE WARNING);
ANSI/ASME A112.19.8M-1987, 2007 WITH ASME LOGO; A #5 RECYCLE LOGO;
HAYWARD'S "H" LOGO; FOR SINGLE OR MULTIPLE DRAIN USE, 125 GPM/SUBMERGED
NSF LISTED; AND FLOOR ONLY, LIFE 7 YEARS ARE ALL MOLDED ON THE INSIDE OF THE LIP PORTION OF THE COVER
|
|
|
|
|
|
|
|
|
|
